Republic Officer The Clone Wars

Model ID-99933, Photo by Cedric Grafas
Imperial-Officer-Corps.png
Description: Republic Officer—The Clone Wars
Prefix: ID
Detachment: Imperial Officer Corps
Context: Star Wars: The Clone Wars

These officers served the Republic Starfleet during the conflict with The Confederacy of Independent Systems.

This is a visual guide used for 501st costume approval, not a how-to for construction. Construction details are found at the costume's Detachment website. Measurements provided here are generalized, and not criteria for approval. All 501st costumes are proportionate to the wearer in terms of size, fit, and scale. During evaluation, both text and images (CRL and Reference) must be considered. When in doubt about a feature of a submitted costume, GMLs should post questions in the Legion forum's DL/GML peer review section.

Required Costume Components

The following costume components are present and appear as described below. For 501st membership only the requirements in black need to be met. This Detachment defines additional, optional costuming details listed in blue and red. Please visit the Detachment website for more details on these options.

• Olive/grey colored fabric is a medium weight suiting material exactly matching the pants.
• Tunic is double-breasted with a left over right closure on the tapered yoke.
• Yoke comes up across the shoulder to the top shoulder seam.
• The standing collar has square corners with a left over right closure in the center.
• Collar includes a modesty panel.
• The tunic has black piping made of matte satin.
• There are epaulettes on each shoulder.
• Sleeves are long, and without cuffs or buttons.
• Sleeves contain 2 seams, one in front and one in back.
• There are two rank-bands of black satin ribbon on both sleeves.
• Tunic is constructed with no top-stitching (stitches visible on the exterior surface of fabric).
• The back of the tunic has one seam that runs in the center of the tunic from the neck to the bottom.
• There is a vent that runs from belt height to the bottom on the back of the tunic.

• Olive/grey fabric is a medium weight suiting material exactly matching the tunic.
• Trousers are riding breeches with semi-stiff flares to the hip/thigh area and tucked into the boots.
• Pockets are acceptable but shall not be visible with the tunic on.

• The rank bar is worn on the left side of the tunic above the piping.
• Rank consists of colored plastic tiles mounted inside a frame-plate.
• The upper and lower frames are divided by a small indentation.
• Three red tiles in the top frame.
• Two blue tiles in the bottom frame.

• The belt is constructed from a non-textured leather or a leather-like material and is approximately 2" (51 mm) wide.
• There are no loops on the belt.
• The buckle has rounded corners and constructed from a horizontally brushed metal, or metal looking material.
• Buckle is adorned with a Republic code disk in the center.
• The Code disk is a stepped cone shape appearing to be 2 disks stacked on top of one another.
• The larger disk is 1.4 inch (3.5 cm), the smaller disk is 1 inch (2.5 cm).

• If stretch panels or zippers are present they are to be hidden on inner shaft.
• Boots are bulged wider on both sides of the ankle.
• The upper edge of the shaft is cuffed.

• Gloves are made from black leather or leather-like material; gloves can be plain or have 3 stitch lines on the back of the hand.